Acoustic transmission

Acoustic transmission in building design refers to a number of processes by which sound can be transferred from one part of a building to another. Typically these are: Airborne transmission - a noise source in one room sends air pressure waves which induce vibration to one side of a wall or element of structure setting it moving such that the other face of the wall vibrates in an adjacent room. Structural isolation therefore becomes an important consideration in the acoustic design of buildings. Highly sensitive areas of buildings, for example recording studios, may be almost entirely isolated from the rest of a structure by constructing the studios as effective boxes supported by springs. Air tightness also becomes an important control technique. A tightly sealed door might have reasonable sound reduction properties, but if it is left open only a few millimetres its effectiveness is reduced to practically nothing. The most important acoustic control method is adding mass into the structure, such as a heavy dividing wall, which will usually reduce airborne sound transmission better than a light one. Impact transmission - a noise source in one room results from an impact of an object onto a separating surface, such as a floor and transmits the sound to an adjacent room. A typical example would be the sound of footsteps in a room being heard in a room below. Acoustic control measures usually include attempts to isolate the source of the impact, or cushioning it. For example carpets will perform significantly better than hard floors. Flanking transmission - a more complex form of noise transmission, where the resultant vibrations from a noise source are transmitted to other rooms of the building usually by elem

nts of structure within the building. For example, in a steel framed building, once the frame itself is set into motion the effective transmission can be pronounced.Room within a room A room within a room (RWAR) is one method of isolating sound and preventing it from transmitting to the outside world where it may be undesirable. Most vibration / sound transfer from a room to the outside occurs through mechanical means. The vibration passes directly through the brick, woodwork and other solid structural elements. When it meets with an element such as a wall, ceiling, floor or window, which acts as a sounding board, the vibration is amplified and heard in the second space. A mechanical transmission is much faster, more efficient and may be more readily amplified than an airborne transmission of the same initial strength. The use of acoustic foam and other absorbent means is less effective against this transmitted vibration. The user is advised to break the connection between the room that contains the noise source and the outside world. This is called acoustic de-coupling. Ideal de-coupling involves eliminating vibration transfer in both solid materials and in the air, so air-flow into the room is often controlled. This has safety implications, for example proper ventilation must be assured and gas heaters cannot be used inside de-coupled space. [edit]Noise cancellation Noise cancellation generators for active noise control are a relatively modern innovation. A microphone is used to pick up the sound that is then analyzed by a computer; then, sound waves with opposite polarity (180 phase at all frequencies) are output through a speaker, causing destructive interference and cancelling much of the noise.